RESISTOR INSTALL GUIDE/HELP
Dual filament bulbs
(1157, 3157, and 7443)
there are three wires on dual filament bulbs.
**ITS ALWAYS BEST TO USE A TEST LIGHT BEFORE INSTALLING THE LOAD RESISTOR ON TURN SIGNALS.
CONNECT EACH SIDE OF THE RESISTOR ENDS TO THE NEGATIVE - GROUND WIRE AND THE POSITIVE + BLINKER/BRIGHTER MODE WIRE.**
Tip** usually the outter wires are the ground and turn signal wires. Not all vehicles are the same. its always best to usE a test light.
(1157, 3157, and 7443)
there are three wires on dual filament bulbs.
- One shared - negative Wires
- +positive dim/running light mode
- +positive brighter/blinker mode.
**ITS ALWAYS BEST TO USE A TEST LIGHT BEFORE INSTALLING THE LOAD RESISTOR ON TURN SIGNALS.
CONNECT EACH SIDE OF THE RESISTOR ENDS TO THE NEGATIVE - GROUND WIRE AND THE POSITIVE + BLINKER/BRIGHTER MODE WIRE.**
Tip** usually the outter wires are the ground and turn signal wires. Not all vehicles are the same. its always best to usE a test light.
SINGLE FILAMENT SOCKETS
(1156, 3156, 7440)
there are only two wires
simply tap the load resistor wires in between these two wires.
(1156, 3156, 7440)
there are only two wires
- +positive wire
- -negative wire
simply tap the load resistor wires in between these two wires.